Drinksafe Lockers

Installation

Install a batten to the required wall using suitable wall fixings at a height of approximately 980mm above finished floor level. The batten should be level and the same length as the bank of lockers you intend to install (see configuration page)
Once you have the batten installed, locate a locker flush with one end of the batten
Mark the location of the narrow ends of the keyhole slots on the wall.
Remove the locker and install suitable fixing at each of the locations you have just marked out. Leave the fixings loose at this stage.
Replace the locker by placing the key hole slots over the newly installed fixings, once the locker is in place, tighten the fixing up, so that the locker is secure.
Now located your next locker tight to the first and repeat stages 3 to 6 until all you lockers are in place.